Carburetor Rebuild Kit for Edelbrock 1405 1406 1407 1408 1409 1410 1411 (With Bowl Cover Gasket)

Excellent kit with all the correct parts including a couple options for the accelerator pump discharge according to the particular carb model. mine is an Edelbrock 1406. Good floats, no leaks. All gaskets needed were in the kit and fit well.No instructions but if you need them it can be easily found on the internet. I highly recommend this kit to save a few bucks.

Gaskets are a little large but got the job done for an edelbrock 1406

Junk kit, the large gaskets were bent even though the box they came in had no damage. Also the smaller gaskets for the venturis had the correct holes but the outer diameter had to be cut down to fit

Complete kit

Nice kit. Everything you need included for edelbrock or carter carb

Its a good kit but Amazon delivered is a bit rough on the brass float bowls. They were dented and bruised up.

Currently I am working on a 1968 ford f100 4x4 high boy with a Edelbrock 1406 carb with electric choke. I bought this because I am a high school senior so my budget is only so much. well anyways I bought this because my truck was acting like there was something plugging the jets and isn't getting fuel. so I bought the rebuild kit and once it came I tore apart the carb at my school because i have shop class and used our sonic cleaner to clean the main part of the carb and all the jets and sprayers. after that i put in everything that the rebuild kit needed replaced. but to note there are 4 carb float needles two of the flote needles are a normal needle that is for performance and getting the most horsepower out of the engine. then there are needles that have a spring that is separated that has to be put together that is more for off-roading. the reason it has the spring in it is for more stability. I put the ones with the springs in because I live on a gravel road and where I live is mostly gravel so I put those needles in . the only problem is the little gaskets for the sprairs to feed the engine with fuel were a little snug on the screws and ports but nothing to be worried about. also after putting all the new components in. The flotes will need to be adjusted. you can watch youtube videos to see how much they need to be set and how to properly set them. after getting this back together the carb worked perfect after doing a toon up so I would suggest this to someone that is on a budget like me.

Fast service nice quality